2005 Jeep Liberty "clear gas cap code" Questions

...gas cap for seal. check the seal on the gas cap. make sure it is clean. no rust on the filler neck. if there is rust, clean with sand paper and coat with grease. if that is all good it could be purge ...

...Speed Actuator Speed sensor is faulty or has a bad connection. try clearing codes. 2 of 3 related to airfuel mixture and can be set off by gas cap challenge. if same codes come back diagnose ...

...codes now with CEL lamp.... all jeeps do this test. there is no other way. sorry, the DTC can clear (error) is 3 trips) some faster. even the gas cap loose can trip a DTC for EVAP , like millions

...Gas cap left off, not tightened, not installed correctly, or needs to be replaced 02 sensor Engine misfire - error might clear itself after 3 complete warm-up cycles; not restarts, but warm-ups At ...

...tighten the gas cap and clearing the code. In most cases the code can be clear by disconnecting the car battery for about 30 minutesRead more: ...

...after fueling up and drove the car too long with cap loose. -or a bad gas cap. I'll try tighting the gas cap. clear check engine. if code come back, replace gas cap and clear check engine light

clear codes, 2-3 months later the codes come back. Happening for about a year. What could cause an intermittent problem with the evap system like this? This has been happening intermittently for about

...gas cap, clear the codes, and drive for a day and see if the codes come back. Otherwise, replace the gas cap, and/or Inspect the EVAP system for cuts/holes in tubes/hoses (you may hear a vacuum noise ...

...gas cap and reseting the ECM to clear the service engine light. If you can not clear the code it takes about three start up with out any issues to clear the code and after 100 start up's the codes ...

...gas cap is on. Why? The same time the check gas cap came on the check engine light also came on. The gas cap indicator sometimes goes off but the check engine never goes off. This has been going on ...