...makes clunk sound but it does`nt happen all the time my jeep has 90,000k miles could itbe a shock or a ball joint? HAVE YOU CHECKED THE BALL JOINTS ? jack it up and raise one of the wheels off the ...
...makes a clunking sound around my rear driver side also when hitting a bump. could be a strut bushing,or shock bushing, or a ball joint, check all three and rule them out. ALSO MAKE SURE ITS WHEN YOU ...
...clunk sound when I go over the dip in the road where two roads meet. It is a light sound that doesn't seem to affect the performance of the car but is annoying in an otherwise wonderful vehicle. I ...
Question about Cars & Trucks
I am getting a huge clunk in the front end of my 1997 Ford F-250 when turning into a driveway with any type of dip to it. It seems to only make the clunk if I turn to the right into a drive way with a
Question about Jeep Wrangler
...sound. Just had new brakes, rotors put on make sure calipers are tight to their brackets. seen alot of mechanics leave these 2 bolts loose and the clunk u hear is the caliper smacking back n fourth ...
...car overheated or been run really low on oil? Could also be a blown head gasket. But the clunking sound when you hit bumps makes me think the one of the cylinder heads is cracked. But oil in the ...
Question about Nissan Cars & Trucks
...makes intermittent clunking noise when accelerating. What might be the cause? can be anything --exhaust loose ant part in suspension --motor/trans mounts--axles--hubs etc OK. I'm going to need more ...
Question about Jeep Wrangler
...car I cannot figure this one out...I don't really know a whole lot about cars but it makes this deep clunking noise followed by a slight rattle. I cannot hear the noise outside of the car ...
...car doesn't move. I put it into neutral and pushed it with the help of a few friends. It was locking up at first while in neutral and moving. I put it into reverse and it clunked, moved back about 5 ...
...sound good. The noise is caused by the axle button being worn out, this lets the axle move back and forth and clunk, this is a unique problem with C clip retained axles, it is a noise issue but will ...
383 questions posted
Usually answered in minutes!
635 Questions
545 Questions
532 Questions
469 Questions
339 Questions