Question about Jeep Wrangler
...3 gears starts to bog down. the idle high then low not a consistent idle rate Seems like you got a fuel pressure issue.Bogs down in 3rd. .Then idle high and low.Also check the MAP sensor its up along ...
...3-4000 rpms. every now and then it'll act normal and the rpms will be between 500-750. how do I fix this? Find your vacum leak. It is sucking in to much air. Rather than just a vacum leak it sounds ...
Question about Jeep Wrangler
...idle cam
2:carb running rich with vacuum leaks
3: dash pot valves on CARB sticking.
4:gun under throttle plate
left air cleaner
if choke is closed, open it by hand
done 1000 ...
Question about Jeep Wrangler
...3 jeeps like a 100 times. in 500k miles total. its just a simple stepper motor. keep in mind fast idle speed is a feature of the ECU. magic, to prove i have leaks , on my 4.0L i removed the IAS ...
Question about Jeep Wrangler
...3: jets not clogged, inside carb. 4; carb computer working (Tests stated in SM) 5: dead carb solenoids. there is no worse car than a ECM controlled carb. horrid system. ended in 91. as Chrysler took ...
Question about Jeep Wrangler
...3 nuts, plus the actuator rod that pops off once you release the clip. Use a small flat-bladed screwdriver to loosen the little locking tab on the end of the lower ball-and-socket. The plastic ends ...
...idle was acting erratically (idling high, followed by very low (near stall) idling. Also, it is giving me rough acceleration right as I shift to each gear. Anyone have any input? Dear atomicboy488, A ...
Question about Jeep Wrangler
...3:ISC stuck closed (in fact all air valves, sticking for idle controls) 4: misfiring for huge list of reason... (have list but is useless. we do that tests) 5:flooding, (more tests) 6: weak or bad ...
Question about Jeep Wrangler
...IDLE ALL DAY WITHOUT IT BLOWING. which engine? 4.0L? which trans, stick or a/t?
can you show the location of the fuse exactly.
each fuse has number and the schematics show only the F ...
...3 transistor.. see same form for fix for that issue.. i think this is same as your. 1996 is big change year. http://www.jeepforum.com/forum/f12/1993-wrangler-pcm-ecu-ecm-pin-out-diagram-1170004/ you ...
367 questions posted
Usually answered in minutes!
635 Questions
545 Questions
532 Questions
469 Questions
339 Questions