Question about Jeep Liberty
...starter, and locate the wiring harness coming from the key switch and disconnect it. If the "clacking" stops, replace the key switch. If it doesn't, then you have a short, or wire harness problem. At ...
Question about Jeep Liberty
starter solenoid when key is held in crank position. If power there, the solenoid must be bad. If no power the circuit from ignition switch to the starter solenoid has a problem ( like the
Question about Jeep Liberty
...starter solenoid. Might try tapping the solenoid with chunk of wood, and clean battery connections and check condition of cable ends. The cable ends can look fine and still not make good connections ...
...starter relay aswell as other wires tying in to go to the positioning ignition switch that could be the problem to, it's commonly mounted down but your foot pedals on the top of the ...
...starter solenoid trigger(purple)wire,will start with key on and jump terminal at starter,will also start if I pull starter relay and jump across 85 and 86 pins and turn key to run once running must ...
Question about Jeep Liberty
...wires that operate the starter solenoid. This means your secondary solenoid is no good. There are two solenoids on this vehicle the one on the wheel well next to the battery is referred to as the ...
Question about Jeep Liberty
...starter wires. Remove the nuts. Disconnect the wires.Remove the nut and the starter ground cable Remove the bolt and the starter motor. Follow the removal procedure in reverse order. NOTE: When the ...
Question about Jeep Liberty
...starter solenoid just to stop those no starts. From the ignition switch is the black/white start wire, it is hot only in start, goes direct to the "starter cut relay"- a 4 pole starter relay, the ...
Question about Jeep Liberty
...starter solenoid when no signal is transmitted? The wire from the ignition switch doesn't go to the starter solenoid . The wire at the starter solenoid comes from the starter relay in the battery ...
...coming out of the clutch switch. If no power out, clutch switch may need adjusting or replace. If power so far is good, now move to the starter relay. First, you need to locate this relay. The wiring ...
2,523 questions posted
Usually answered in minutes!
839 Questions
768 Questions
735 Questions
633 Questions
207 Questions