...needed. Do not remove the distributor connector from the distributor. Using small paper clips, insert them into the backside of the distributor wire harness connector to make contact with the ...
...tool do I need to remove the distributror cap,screwdriver or allen wrench or what? vehicle is a 1999 chevy silverado 4.3 V-6 Those older GM distributor caps can require a 1/4" socket, 7mm socket, ...
tool, coat entire interior surface of boot with Silicone Dielectric Compound WA-10, D7AZ-19A331-A (ESE-M1C171-A) or equivalent. Insert each wire on proper terminal of distributor cap. Ensure wires are
...Remove the spark plug wires from the distributor cap. On some models you may need to use a flat bladed tool to lift up the lock claw and disconnect the holder from the cap. Separate the wires at the ...
...tool to remove the bolt holding the lock down clip at the base of the distributor. dont let it fall Murphy law says it will fall where you cant get a hold of it lol. after removing the lock down clip ...
remove the distributor cap and rotator and I see the iron rod that the rotator sit on but I don't know what to do from that point. and will I need any special tools to do this. I have another question
...distributor cap and rotor button? Are there special tools required to remove the above items? If so, what are they? no special tools. phillips screwdriver is all you need. critical part is getting ...
Question about Dodge Cars & Trucks
...remove the distributor cap and manually rotate the engine until the rotor inside the distributor is pointing at the #1 spark plug position on the engine block. Once you have identified the correct ...
Question about Cars & Trucks
tool. Is the camshaft retard reading within the second specified value? 1000 RPM -5° to -17° Go to Step 5 Go to Step 6 5 Note the camshaft retard reading from the previous step. Raise the engine speed
...move it to the side.remove the rotor in the center.remove the distributor. upon istalation of new one the slot at bottom of distributor only goes on in one position then reinstall rotor and the
2,523 questions posted
Usually answered in minutes!
839 Questions
768 Questions
735 Questions
633 Questions
207 Questions