...solenoid sticking on the starter motor. If not could simply be the solenoid starter wire with a loose or poor connection? Locate the starter and then when you try to start listen to see if making ...
Question about Jeep Grand Cherokee
Starter solenoid. I don't have the page here but in chiltons a page shows the ignition to fuse to relay to starter and if you look closely it's quite basic. I had same problem with constant fuse blow
...sticking on there are two possible causes the ignition key switch spring has broken or is worn out. or the starter motor solenoid has become faulty and should be replaced but means you will either ...
Question about Cadillac Cars & Trucks
...check 1 make sure the bendix is not sticking holding on the solenoid , the solenoid lets more power flow to the starter from the battery. 2 faulty solenoid, 3) faulty ignition switch... hope that ...
starts, if it's a sticking solenoid. If your'e skint like me, it's not impossible to dismantle starter, remove solenoid, and clean with wd40, done it myself on freelander, no probs, but time consuming
Question about Chrysler Cars & Trucks
...sticking but the engine didn't turn on. this is on a 2007 Chrysler aspen 5.7 Hemi You may not have enough charge in your battery or it could be the starter relay or solenoid. The starter motor itself ...
Question about Jeep Grand Cherokee
solenoid is sticking replace it or the complete starter I hope this helps you Starter motor spindle could be sticking in the out position. Remove the starter motor and clean and lube the spindle so it
Question about Isuzu Cars & Trucks
...sticking solenoid on your starter motor check and clean the wires first hit the solenoid with a spanner/wrench get someone to turn the engine over as you do this .if it starts replace the
Question about Suzuki Cars & Trucks
solenoid on the starter to stick, causing it to continue cranking just like the relay being stuck, this can burn out your starter. You could also have a defective solenoid on the starter. The ignition
...sticking on the starter shaft or the solenoid is not pushing the gear into the flywheel . You will have to take the starter motor off and bench test it to see what the problem is. It is typically ...
3,397 questions posted
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,715 Questions
2,521 Questions