2001 Jeep Grand Cherokee "replace 2003 hole tail light" Questions

checked fuse and relay under hood. Brown wire feeding tail light o volts even before disconnect plug under neath bed. The wire may have a break inside its insulation you may have to replace hole wire

intalling brake lights can't get inside tail light assembly to replace bulb u must remove the hole assy

...2003 tiberon replace the bulb ? In the trunk there are two panels that are located right behind each light you remove the panel by unscrewing the three butterfly screws that hold each one on. Next ...

...hole so the tail light can be separated from the car replacing the bulb at that point is pretty straight forward just repeat the steps when you put the lights back on but test the lights before ...

hole but every time it rains or the roads are wet my trunk gets full of water. I was thinking that the gaskets needed to be replaced obviously but autozone did not have them neither could they tell me

tail lights in a Town and Country Van. How do i remove the unit from the vehicale, no screw or bolts, just 2 knobs. Open your tailgate. Look for two (2) round flat black discs about the size of a dime

...replace in less than a minute (or temporarily patch with duck tape). Is called a Brake bumper and is at the end of the brake pedal. I just solved it in my Hyundai Santa Fe 2003 V4. I found the EXACT ...

...2003 ford focus 2.0 SOHC SPI. I am not getting a service engine light and the car has a bad missfire. It idles really rough and when you put it in gear it pretty much dies every time. I have replaced ...

2003 I just changed the taillight on my rx 300. Lift the hatch expsing the the edge of the taillight assembly. It is held in place by two phillips head screws, but the screws are not visible until you

on the tail light The lens can not be changed you have to replace the complete tail light.It is a sealed light except for a breather hole to keep it from building up moisture.Hope this helps.Good luck