2001 Jeep Grand Cherokee "intake manifold" Questions

...intake manifold on a 1995 grand cherokee V8 5.2 I broke an EZ out in the thermostat housing hole. I can't get it out. Please watch the video. 98 Grand Cherokee 5 2 V8 318 MOPAR M1 Intake Manifold ...

intake manifold? I have a 96 grand cherokee v8, unable to replace the thermostat housing to the manifold because one of the screw holes cracked off on the manifold. Position The Intake Manifold Gasket

...intake manifold with 2 screws.4.0L - On the 4.0L six-cylinder engine the MAP sensor is mounted to the engine throttle body. On the 4.7L V-8 engine the MAP sensor is mounted to front of the intake ...

intake manifold. An O-ring seals the sensor to the intake manifold. (click over image for zoom) Disconnect electrical connector at sensor. Clean area around MAP sensor. Remove 2 sensor mounting bolts.

...intake manifold and runs by the top of the firewall. One end goes into the intake manifold for vacuum and the other goes into the passenger side fire wall where the aluminum ac hoses go in the cabin ...

intake manifold sensor You should be more specific. There is an intake temperature sensor and an intake manifold pressure sensor (MAP)

i need to know what the part is called that goes from the top of the motor to the intake manifold The top of the motor is the intake manifold. Not sure what you mean.

...Intake manifold) gasket is worn maybe you are missing a bolt or you may have a cracked manifold. it usually means an intake valve isn't sealing. check to make sure the timing belt is okay. if it is, ...

...intake and exhaust manifold bolts front front to back. You will see that some are exhaust manifold bolts only and the other share responsibilities of holding the exhaust and intake to the heads. ...

...intake manifold and vacuum hose. Bad Idle Air Control Motor (IAC) Low compression (170 psi + is OK) Start cleaning and repair these trouble spots and see is there any improvement. ==== For more ...