...3) Insert head restraint sleeve extractor (special tool 6773) (Fig. 1) and (Fig. 2) into the seat back. (4) The retaining tabs are positioned on each side of the sleeve, when inserting the extractor, ...
head gasket and need to find the lbs of torque. Thank you for any advice, pictures, etc. Torque sequence ------------------ front | 12 8 4 1 5 9 13 | of | | engine | 11 7 3 2 6 10 14 | ---------------
...the engine was assembled there could be a few Torx type bolts used to hold certain brackets to the intake manifold and or heads the head bolts will either be ASE 3/8 or 7/16 or 13- 15 mm. please ...
...Removing the Radiator 1 Loosen the hose clamp that connects the upper radiator hose to the radiator using a Phillips head screwdriver. Then pull the upper radiator hose off the radiator. 2 Loosen the ...
...head 4.7L see page 4750 for that warning on removing 4 bolts first. not reading the FSM invites huge blunders. see page 4751 on the bolt inspections. im guessing your engine. so do look and read the ...
Question about Jeep Cherokee
...3 people said sounds like a cracked head or head gasket but wouldn' ;t that make it overheat? you are air locked in the heater core you will have to remove one heater hose and fill anti freeze ...
...3 and4 cylinder.i changed wires,plugs cap,rotor, coil pack and still runs bad.looking for a answer please test the compression, also look for a intake manafold leak, take a can of carb cleaner and ...
Bearing Noise in front diff I have a 2003 KJ,2.8 diesel with 108,000km done.It has developed a bearing noise from the front diff'.Is this a common problem with this car and what would you say is the ...
...head bolts, in sequence, as follows: Step 1: 22 ft. lbs. (30 Nm) Step 2: 45 ft. lbs. (61 Nm) Step 3: 45 ft. lbs. (61 Nm) Step 4: Bolts 1?10 to 110 ft. lbs. (149 Nm) Step 5: Bolt 11 to 100 ft. lbs. ...
...3 screws covered by little plastic covers near the door armrest and door release. Remove those then using a flat head screwdriver carefully pry the panel away from the door. You'll want to move the ...
926 questions posted
Usually answered in minutes!
1,380 Questions
1,162 Questions
698 Questions
672 Questions
325 Questions