2000 Jeep Wrangler "engine knock" Questions

...knock sensor...sensor has been replaced, but check engine continues to come on...have always used premiun gas...do have a airaid cold air intake..2009 jeep wrangler with 8000 miles it could be that ...

...verify the actual oil pressure using a mechanical gauge. Lowest pressure at idle, with a warmed up engine would be 20psi. I'd rather see it at 30. If the pressure is good, then you could have a ...

wrangler 4.0 is leaking oil out the top the engine block oil appears to be coming from around the pvc valve but dont see any leaks also kinda knocks just like something is loose inside engine wonder ...

...knock again at idle. It may be piston slap. This is caused by either engine wear with the piston bores being too large for the pistons, or by poor manufacturing tolerances, or a combination of both. ...

engin makes knocking sound when i start it in cold weather Try switching to a full synthetic oil, will flow better in cold weather and may stop the knocking.

have a1997 2.5 jeep wrangler. when u start the engine it runs and sounds fine but after a few seconds it starts a consistant knocking noise. removed valve cover and all the valves seem to be working ...

Oil gauge does not work, engine runs fine It is probably your sending unit, if your engine hasn't started knocking or seized by now it is probably fine. Either change the unit where it sits or have a ...

I have a jeep wrangler 2004, when i start the engine it work good, but when trot to go front i hear noice from the engine tak tak tak tak Can you help me with this problem? sounds like you have a rod ...

...engine is usually "rod knock," a condition brought on by extreme bearing wear or damage. If the rod bearings are worn or loose enough to make a dull, hammering noise, you're driving on borrowed ...

...engine will self destruct soon. ping or knock is cause by lean mixtures and very hot combustion, all very bad, do not go up hills that makes this worse. i say get a shop to check it out. before it ...