will not accelerate wont even rev past 3500 rpm's will not go faster than 55 mph eigther most likely a clogged cataytic converter. Remove the 02 sensor. and drive; if better replace the catalytic ...
92 wrangler engine will not rev above 3500 rpm under a load Check your distributor bearing. I had a car that had the same problem. It was the distributor bearing, it didn't allow the distributor ...
Engine idles between 3500 and 4000 rpm vaccume leak some where
the money? I current have a basic $12 air filter in my 2007 Jeep Wrangler. In June, I am going on a 3500 mile road trip and want the best gas mileage possible. I am considering buying a K&N filter
...a 92 wrangler 2.5 liter. after driving for a little while the engine starts cutting out at around 3500 rpm. if you turn the switch off and then back on it clears up for a little while. it can
...mentioned below:---- Click the link :---- Cold start problem and vehicle shudder around 2500 to 3500 rpms http://repairhelpcenter.blogspot.com/2012/10/cold-start-problem-and-vehicle-shudder.html
...specifications on the chip, you will find that most of the advertised performance gain is way over 3500 rpm (out of the usable torque curve of the engine). Doubtful that it will give you the "boost" ...
...a idle it would ilde ok then drop down but would come back up and idle and now it races up to 3000 3500 rpms we discontected both the tps and tbi no change then took off the vacuum to the map sensor ...
...jeep wrangler map sensor location on motor I have a 94 jeep wranger just started to idle at 3000-3500 rps checked the tps and tbi no change but remove the vacuum line to map sensor idle lowers
491 questions posted
Usually answered in minutes!
635 Questions
545 Questions
532 Questions
469 Questions
339 Questions