...unplug it where it joins the dash harness. If all the windows and switches in the donor vehicle are good, you can just plug it back in when you hang the door. If not, you have plenty of spare parts ...
...door, lights, and heating controls). but, before you go about replacing any switch, unplug the harnesses and clean the connectors carefully with some rubbing alcohol, fine git sandpaper, and a little ...
Question about Jeep Grand Cherokee
Communications Interface (PCI) data bus communication between the two door modules. (bar stool answer) all cars. mostly pull door skins unplug motor conn. unscrew mirror base from door. extract mirror
...door panel, unplug the wire harness, pull it through the inside of the car so you have access to the wires. If one is proken, there is the problem. Match the wire, extend it and repair. That should ...
...is. That has to come off. In some cases the door panel has to come off also. Under the mirror panel there are nuts that hold the mirror on. Remove the nuts unplug the harness and install the new
...harness are left unhooked. I have a 1995 Jeep Grand Cherokee LTD. I removed the dash to replace the blend door in the HVAC assembly. I got the blend door replaced and when I put it back together the ...
...Unplug the wire harness connector from the blend door actuator 4. Remove the 2 screws that secure the blend door actuator to the HVAC housing. 5. Remove the blend door actuator from the HVAC housing. ...
...door gently and unplug the wiring harness from it. it is possible to repair the window winder assembly inside the door, but its too hard a process for me to explain. if u can get the door panel off, ...
...Unplug the wire harness connector from the blend door actuator. Remove the 2 screws that secure the blend door actuator to the HVAC housing. Remove the blend door actuator from the HVAC ...
4,475 questions posted
Usually answered in minutes!
3,350 Questions
2,899 Questions
2,715 Questions
2,521 Questions
2,639 Questions