2000 Jeep Grand Cherokee "makes coolant push back radiator" Questions

...coolant in the cylinders. I know it's a pain to keep going back and checking, but you gotta be thorough. Plugs may be blistered white from overheating, but if you get it fixed, they should be ...

...Coolant loss is caused by either a thermostat going bad, causing an overheat that will push antifreeze out of the overflow. If you saw it leaking, you should have looked and noted the exact location ...

...coolant hose to push out the air and this should make the cooland level drop. top up the coolant through the radiator cap - not the reserve/expansion tank. with the rad topped up to the brim, put the ...

...back to my work by holding gas and breaking while drove. It finally started without pushing gas to floor drove around parking lot and died through a puddle. Left it there and next morning engine ...

...back to my work by holding gas and breaking while drove. It finally started without pushing gas to floor drove around parking lot and died through a puddle. Left it there and next morning engine ...

...pressure, and letting coolant go into the overflow tank. When the engine is at normal operating temperature, the coolant is in constant circulation from engine to radiator and back into the

...makes it had to see the coolant because it doesn't leak much and it boils off leaving little or no evidence. Fill the system completely before pressure testing. Remember, checking the overflow tank ...

...coolant light sensor,and clean it off,it is located on passengers side in the radiator,it has a wire clip you have to remove,and dont loose it,after cleaning it,put the clip back on the sensor,and ...

...push the coolant out. Randy REPLACE THERMOSTAT IF TOP COOLANT COOLANT HOSE GOING TO RADIATOR IS HOT TO TOUCH THERMOSTAT OPEN. TO BLEED COOLANT SYSTEM FIRST YOU NEED TO ADD COOLANT TO THE COOLANT OVER ...

...coolant back in to the radiator from the resevoir. If it is not woring you may not have it sealed right. Make sure the radiator cap is all the way on correctly. You may have to push down and turn it ...