2000 Jeep Grand Cherokee "ignition lock cylinder turn" Questions

...ignition lock clinder retaining tab ... Fig. Fig. 4: ... then pull out the lock cylinder from the steering column With the ignition switch still in the ON position, insert a thin screwdriver into the ...

ignition lock cylinder with the plastic end of a scrwedriver (with the key removed). then insert the key and try to start. Try this several times. If you get it to turn immediately replace the igntion

...at jeep and this is very common. you need a new ignition lock cylinder. easy repair but you need to buy it from a dealer and bring the key and lock cylinder to a locksmith to get it coded **** ...

...the internal lock. Are the wheels against a curb or object? if so turn steering wheel to relieve pressure on ignition lock. other wise lock cylinder maybe worn out and will need replaced. Good

...lock position and remove the key and key cylinder. Step 6 Install your old key cylinder into the new ignition switch assembly. Make sure the contacts in the cylinder and assembly line up. Reattach ...

...ignition lock switch when it is stuck in the locked position You will have to remove the steering wheel, lock plate, turn signal switch,  and lock bolt for the cylinder and remove the cylinder, ...

key is worn out it may not turn well in the ignition. Another thing is to lubricate the ignition cylinder. If nothing works, it maybe the ignition cylinder tumbler is worn out and needs to be replaced

...ignition key will not turn. I have pressed down on brake. steering wheel is not locked. gear shift is in park. take a small hammer and tap the lock cylinder where the key goes in then retry. if this ...

ignition key lock cylinder (the thing you put your key into). once you've removed the cylinder from the steering colum you should test your key again to see if you can turn the cylinder outside of the

...not the cure. Then you, may have a key cylinder that's broken. the ignition switch is located at the bottom of the steering column. the tumbles inside the lock cylinder are jambed so replace the ...