2000 Jeep Grand Cherokee "fan car cuts alot" Questions

fan cooler of cherokee, I know that is located under the passenger side headlight, what parte I can remove to replace them. You will need to remove the passenger side headlamp assembly. Once it is out

...fan relay is bad- the computer dies on this model alot. you can access it under the Passenger headlamp it is a bad location and you have to cut a little hole in the plastic after the headlamp is ...

alot of slack in the wire, but enough to pull the relay out of the hole and disconnect it. Note that the electrical plug has the same sort of locking clips as other locations in the engine compartment

...fan is not turning to keep my car cool. i ruled out that the fan motor is good now i was trying to change the fan relay (behind the bumper )to see if that will fix the problem but i am not to sure ...

...fan motor would run until I let go. One of the wires was broken behind the insulation in the top of the connector. And naturally these connectors are usually dealer items not available at your chain ...

...fan is not spinning it could also be because you are not getting power. I cut the positive wire and connected it directly to the battery to test it. A third problem I had was a leak in from my water ...

...fan stayed on and after I pulled the fuse it will not come back on? no relay.....do you have manual A/C or electronic? if electronic the controller is near the blower motor. Under the hood in a black ...

...car seems to use alot of engine coolant, the themostat is working fine - goes cool to hot regularly. When parked up there are no leaks - parked inside every night. Fan cuts in when it should - at a ...

...VEHICLE OFF,GRAB FAN (IF EQUIPPED) AND ROCK IT UP AND DOWN..IF NO FAN,GRAB PUMP PULLEY..CENTER PULLEY AND DO SAME..IF IT MOVES ALOT,YOUR WATER PUMP IS GONE..CHECK FOR ANY CUT HOSES,ETC.. ...

...fan of the mk1 golf. hi, their is no reason why it wouldnt fit but it would take alot of work to make it fit you might have to cut pieces out of the golf parts to make them smaller or bigger to fit. ...