2000 Jeep Grand Cherokee "cable replacement throttle" Questions

Ad

...throttle cable and the return spring. Disengage the wire harness connector from the injector. Disengage the wire harness connector from the WOT switch, ISA motor and TPS. Disconnect the fuel supply ...

Ad

Question about Jeep Grand Cherokee

1 Answer

...throttle cable. That is a cable just like the one that operates the hand brakes on a bike. It moves the valve on the throttle body as you push down on the gas pedal. The cable is replaceable as well. ...

Ad

Question about Jeep Grand Cherokee

1 Answer

...bodyis clear and clean and that the throttle plate is able to close all the way. Disconnect the cables from the throttle body and make sure each is free to move without binding and that any

Question about Jeep Grand Cherokee

1 Answer

...to just behind the air intake, to the throttle body. (This is on the 4.7L V8 engine.) Check for that cable being connected at the throttle body. That connect is adjacent to the accelerator

...inside the air input tube of the intake manifold (where the "flap" would be located on an old carbureted car air filter It will be on the opposite side of the throttle,where the throttle cable hooks ...

Question about Jeep Grand Cherokee

2 Answers

Tps

...be right in that area where the hose connects to the intake throttle body. It should have a harness plug. it is located in the throttle body in the axis where the cable of the accelerator is ...

Question about Jeep Grand Cherokee

1 Answer

...cable nest to the mount it goes on. tighten till there is no slack at "full throttle" then place back on the mount. i would also take the battery off while you do this {abt. 30min} to help reset the ...

Question about Jeep Grand Cherokee

1 Answer

change. The ones to look at is the tps sensor( throttle position ) and the isc( idle speed control) if the isc motor is stuck open or shorted it will cause this.Make sure throttle cable isn't bound up

Question about Jeep Grand Cherokee

1 Answer

...throttle to transmission cable and slide the cable as far in as possible then put the clip back. Next you'll want to press the gas pedal all the way down (may have to use extra force). You'll ...

...cable from the battery. (2) Drain the cooling system (refer to Group 7, Cooling System for the proper procedures). (3) Remove the generator (refer to Group 8B Battery/ Starting/Charging Systems). (4) ...

Not finding what you are looking for?
2000 Jeep Grand Cherokee Logo

4,475 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...