1998 Jeep Wrangler "remove ignition cylinder 1997" Questions

Ad

...REMOVE AIRBAG FUSE OR DISCONNECT NEGATIVE BATTERY CABLE TO DISCHARGE AIRBAG CAPACITOR DISCHARGE  BEFORE YOU  REPLACE IGNITION SWITCH  KEYLOCK CYLINDER. CHECK MAKE SURE YOU INSTALLED ...

Ad

Question about Jeep Wrangler

3 Answers

...ignition coil, as soon as the engine starts to turn over there should be voltage. If not, the crank sensor is not triggering the ECM quickly.... on 98-99 wranglers, this was a problem area. Check ...

Ad

...ignition cylinder from 1997 toyota camry hello, I need to know how to removal the ignition cylinder from my 1997 toyota camry. I have my steering column off I have this thing torn apart but I am ...

...Remove the ignition key from the ignition lock cylinder. Close all of the vehicle's doors. Press and HOLD the door "LOCK" switch to the "Unlock" position. Insert and remove the ignition key twice ...

Question about Jeep Wrangler

1 Answer

Remove the ignition switch lock cylinder illumination miniature bulb from the lower steering column shroud. Remove the upper and lower steering column shrouds. Remove the multi-function switch (13K359

Question about Jeep Wrangler

2 Answers

.... i removed my cylinder and while tryi g to trace the wires tbey broke on me, can anyone tell me where the ignition cylinder wires end and plug in? BeeN stumped for 3 days searching for help like ...

...Check your work. Remove spark plugs. Manually turn engine so cylinder 1 is TDC of compression stroke. Remove distributor cap and verify rotor is pointing directly towards cylinder 1 ignition

Question about Jeep Wrangler

1 Answer

remove the key. I have tried WD-40 around the button already.This part was changed already when the car was 2years old. I am not entirely certain I understand what button you are describing. However I

...ignition cylinder Removing and installing/replacing lock cylinder for steering wheel lock Car with ring antenna: Remove lower section of steering column trim. Using special tool 61 3 300, press ring ...

Question about Jeep Wrangler

3 Answers

...Remove the ignition lock cylinder from the lock module. INSTALLATION 1. Insert the ignition lock cylinder through the upper shroud. 2. Install ignition lock cylinder to the lock module assembly: 2.1. ...

Not finding what you are looking for?
1998 Jeep Wrangler Logo

720 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Jeep Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...