1998 Jeep Wrangler "engine idle" Questions

...idle after engine rebuild? http://schematicsdiagram.blogspot.in/2012/03/stumbling-and-stalling-at-idle-after.html ------------ 1999 Ford F-150 Idles rough and quits when gas pedal is pressed less? ...

1989 wrangler 4.2 litre engine wont idle 1989 jeep wrangler 4.2 litre engine wont idle. engines dies everytime vehcile is stoppe.

engine and it will rich misfire, idle rough, and be difficult to start warm. The ECT has two wires going to it and is dedicated to sending information to the engine computer. It has nothing to do with

...engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the ...

...idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake ...

...engine. adjust one idle screw to highest vacuum reading and highest tach reading, then do the other one. go back to the first and re-adjust again, then the other. I find that if you have a mechanical ...

idle. It may be piston slap. This is caused by either engine wear with the piston bores being too large for the pistons, or by poor manufacturing tolerances, or a combination of both. To test for this

...has a 2bbl carb. It idles at 1000 rpm right now but seems fast or is that about right? Most carb. engines should idle between 725 and 750 R.P.M., lower the idle and be sure to check the timing. You ...

engine has almost no power at that rpm. the normal cold start (winter) is about 1500 RPM. if not at fast idle fix bad fast idle (Bad IAC) when i say bad IAC that means the system IAC is bad,not just a

...idle speed is the same with the engine running in neutral or with the clutch depressed. check the idle air control and clean the throttle plate in the throttle body as well as checking the throttle ...