1998 Jeep Wrangler "amp starting oil pressure switch" Questions

amp; ball attachment on the link rod can break when they are removed from an old engine, have access to extras first if you remove the throttle body from the manifold. One right-hand thread, the other

...oil is full & the light won't go out as you crank the vehicle, there is the possibility of the switch being bad, or internal engine problems. If you have an Oil pressure gauge also, if it's ...

...starting I have a 2005 Dodge Stratus thathas recently begun to shake violently at low speed and the check engine light blinks constantly. The oil light has been occurring for a little longer, but I ...

...amp; INSTALLATION On the 2.4L engine, the oil pressure switch is located on the side of the engine block facing the firewall. On the 3.0L engine, the oil pressure switch is located on the oil filter ...

...oil pressure light & if it stay on when the engine is running it means you have low oil pressure, but it could be a faulty oil pressure sensor , you need to have it checked out to make ...

...amp fuse in, it will start right up. Thanks The first thing you should do is to locate the oil pressure switch/sending unit. This switch serves two functions. 1) provide oil pressure reading 2) ...

...starting the engine. once the engine gets to normal oil pressure the computer will shut the feed off from the oil switch and turns the relay on to take over till you shut the engine off. If the fuel ...

...amp; no power during morning start ups. loss of power during acceleration Code 17 is a problem with the correlation between the cam and crank sensors. The computer can't figure out where top dead ...

...a little bit, but still shuts down. Replaced fuel pressure regulator & fuel pump & oil pressure switch & still nothing. HELP....this is getting very expensive! t.p.s. ...

...oil pressure showing when you crank the motor? Some of the computer systems will cut power to the igntion system if no pressure is sensed, the sender may be faulty. They are also known to corrode ...