...wont unlock/open My wife had an old Nissan that the lock rods came off inside the door, it prevented me from opeing the passenger door. What I had to do is drill some strategic holes to gain acess to ...
...wont unlock how do i get ignitioncylder out of retainer?? Most of the time,you have to drill out a retaining pin,but since I can't physically see your setup,I'm not going to recommend anything,but to ...
Question about Cars & Trucks
wont unlock . the tool box is loaded and heavy as hell cant tip it but can get a fork lift under it to raise it . is there a way to open it from under the box. help i need my tools for work if you can
unlock the anti theft mechanism, do i need to turn it that hard? i dont wont to break it! you may need a new ign lock cylinder, common problem. you will need to turn the key ON to get the cylinder out
...screw These two screws is what holds the door latch to the body which holds the door closed I then drilled a hole threw the bracket and the screws both screws then broke the bracket loose,pushed the ...
Question about Jeep Wrangler
drill out the ignition and broke the blk box changed the steering colum due to passcode security now it wont start mode 3,5.9.4,8,2 oxygen sensor - not ready fuel system BNL1 -disabled EVAP system-not
...wont affect wiring. If still bad you have to drill out the bolts holding the keyswitch on, as soon as its off, its not locked. Bikers often have to do this and there are tools and tips you can use to ...
Question about Jeep Wrangler
...wont unlock There may be an access hole plug at the bottom of the trim panel you can remove to insert a flat bladed screwdriver into the latch tommanually release it. If no plug there may be an ...
...wont have to take anything apart all u need is a drill and a 3/8 drill bit. under your steering wheel u will see where to drill. here is a picture of what it looks like. (see below). drill in the ...
Question about Cars & Trucks
wont turn I had a problem with my freezer several years ago, I lost the key. I took a small drill and drilled a small hole in the center piece of the lock, then I used a tap to tighten up in the hole,
498 questions posted
Usually answered in minutes!
635 Questions
545 Questions
532 Questions
469 Questions
340 Questions