1992 Jeep Wrangler "brake light dash" Questions

...stepping on the brakes or not. You brake light actuator switch under the dash is stuck closed. Look at the shaft attacked to the brake pedal, follow it up under the dash and you'll find the

...brake lights,,no running lights, what should i check ,,could they both be blown 1987 Jeep wrangler Usely dash lights and taillights are on the same fuse, if you don't have dash lights you won't have ...

...brake light and turn signal are on the same bulb. So pull the bulbs out and check to see if they are flat and making contact on the bulb connectors, that's if you have not found the fix for this ...

...light switch then press the brake pedal i get a increase in sound in the flasher and the dash lights flash Sounds like an earth / ground wiring problem at the rear lighting units, when the flashers ...

...brake dash light stays illuminated following a hard brake incident. The light disappears when the brakes are applied and then remains lit after brakes are released. just a little bit low on brake ...

...think I have a blown fuse/fuses. All my dash lights are out along with my tail lights. Can I access my fuses from inside the car with out dissasembling my dash? yes look unnder dash (brake pedal

brake light stays lit HI, this will occur if the brake switch is unstable. this switch should be located under the dash in close proximity of the brake pedal shaft. replace this damaged switch asap. ...

...or any other gauge up there. Is it a fuse of elec, problem? Check 2 fuses. Instument lights / panel and also the brake light fuse. Sometimes the brake light fuse blows and you have no dash

...brake light on a 1985 Jeep Wrangler stays on? The most common problem is the stop light switch on the brake pedal if you're referring to the rear brake lights. Then again, there's a switch on the ...

...brake light not working hazards don't work either but all the other lights work ok checked fuses inside an under the hood and looks ok no brake lights or hazards but all other lights work hi try ...