emissionwiz has asked you to clarify your question to best assist with your how to remove the lower ball joint, trooper problem: do u have the ball joint press?The ball joint is presse3d out; the ...
front right hub and sensor assembly or a diagram Removal Steps 1. Torsion bar 2. Wheel speed sensor (if equipped with ABS) 3. Back plate 4. Lower ball joint 5. Upper ball joint 6. Knuckle assembly 7. ...
trouble removing ball joints you can buy/hire a ball joint splitter......
...ball joints. When taking out the ball joints remove the cotter pin and bolt and beat the **** out of the joint for it to release. Then the C/V axles will come right out with a bit out encouragement. ...
...removing them at the inner CV joint (assuming you have disassembled the knuckle, ball joints, etc. The shaft will hang in there and NOT come out. You can disassemble and remove the CV shaft by ...
cv axle 4x4 diferencial Replacement of cv axle on 4x4 front isuzu trooper 1999 3.5 L Make sure 2- wheel drive is selected. Jack up the vehicle front and support on axle stands. Remove the wheel. ...
boot how do i get the front alse apart to replace a cv boot? I have been told that you need to take the upper/lower ball joints off to remove the whole spindle assy. Good Luck, I have the same problem
...nut on axle/hub with air impact or breaker bar,disconnect tie rods ,ball joints,etc so half shaft can be pulled straight out,usually with a firm jerk or pry gently where axle enters carrier ...
Question about Isuzu Trooper
I am changing the cv boot on the car I have got isuzu trooper 03 I am changing the cv boot on the car I have got the track rod end is off,undone the bolts to top and bottom ball joint, removed brake ...
...Ball Joints, Control Arm Bushings, Pitman Arm, Inner and Outer Tie Rod Ends, Front Hub Bearings. All of these can be replaced in your driveway with the exception of the Control Arm Bushings which are ...
462 questions posted
Usually answered in minutes!
480 Questions
463 Questions
423 Questions
317 Questions
281 Questions