1996 Isuzu Rodeo "replace pcm" Questions

...PCM. If a problem was found, replace the terminal. Check the KS signal circuit between the PCM and the KS connector for an open, a short to voltage, or a short to ground. You can measure the ...

...Solenoid Repair open in PCM purge command circuit Replace purge Solenoid Replace vacuum switch Repair restriction in Evap line or canister or soleniod Repair resistance in purge connector Replace ...

...Replace sensor, still not working what is worng? did you connect any OBD2 scan tool and look. the PCM will tell you if the VSS is dead. flat out tell you. why no scan the PCM and not work blind./?? ...

...replace the #3 ignition coil. It's likely bad. If you don't detect any frequency signal from the PCM on the ignition coil driver circuit indicating the PCM is grounding/ungrounding the circuit (or ...

1998 isuzu rodeo s/ls troble codes p0452 Hi, This fault code is related to a low pressure signal from your EVAP system which is to do with your purge canisiter system for the fuel vapours etc. You ...

What is the regular cost to replace the ECM/PCM computer in a 2001 Isuzu Rodeo 2.2l FI? The cost to replace the ECM in a vehicle will range from $1100 to $2000 on average.

...Maybe but its usually just the way they tell you theyre worn out...coal etc. needs replacing might be cheaper to replace/"swop with shop"...;) could be alt but remember alt is pcm

...pump come on but no fuel pressure to the engine REPLACE FUEL FILTER COULD BE STOPPED UP.ALSO YOU COULD HAVE BLOWED FUEL INJECTOR FUSE OR FAULTY PCM.HAVE VECHICLE SCANNED TO SEE IF YOU HAVE ANY

1996 Isuzu Rodeo won start. 2.6L 4cyl. Not getting fire. Have replaced distributor, ICM, Crankshaft Position sensor, ECM/PCM. Fuel pump not bad, but no noise when trying to start. Any suggestions what

97 Isuzu rodeo v6 motor won't start after disconnecting pcm before disconnecting the battery. Replaced pcm properly still won't start. auto or stick shift transmission? correlation is not always ...