1996 Isuzu Rodeo "pcm" Questions

...on most modern engines. There is an individual coil for each cylinder that is controlled by the PCM (powertrain control module). It eliminates the need for spark plug wires by putting the coil ...

...code 00reodo The knock sensor detects engine detonation, allowing the powertrain control module (PCM) to ****** ignition control spark timing based on the knock sensor (KS) signal being received. ...

...rough road condition like going over bumps or hitting potholes) and helps the power control module (PCM) determine if the changes in the crankshaft speed are due to engine misfire or are driveline ...

...is either in limp-home mode or has lost electrical power. If there are lots of error codes in the PCM, check the under-hood fuse that powers the transmission, and if it pops again, look for a short ...

...Replace sensor, still not working what is worng? did you connect any OBD2 scan tool and look. the PCM will tell you if the VSS is dead. flat out tell you. why no scan the PCM and not work blind./?? ...

...lines or canister Repair open or short in voltage feed circuit to Purge Solenoid Repair open in PCM purge command circuit Replace purge Solenoid Replace vacuum switch Repair restriction in Evap ...

...Evaporative Emission Control System Pressure Sensor Low Input ..... I'm looking at replacing the PCM as my current tests have narrowed it down to that or faulty wiring between the fuel tank and

...do it. just once alldata.com ill pretend USA car. Ok , i looked there is no TCM. so its now in the PCM (ECU) so my guess is your next question will be, where is PCM. look here. see it? ...

...usa answers on USA forum the 3.2L V6 is COP fired here, and the firing order is fixed by the PCM (hard coded PCM firmware programming) fact. FSM quote ! 3.2L VIN W and 3.5L VIN Y engines

...engine light,.?? if the cluster TACH (stock ) is dead. then its bad, or the wires from it to the PCm. are bad. of other cluster gauges or lamps are dead, the fuse blew to the cluster. that is all