Question about Chrysler PT Cruiser
...fuel pressure gauge on 2006 pt cruiser to check fuel remove the plastic hard line that supplies the fuel rail from either end. The end near the firewall is easiest but i remove both to check pressure ...
...fuel pressure testing it don't rev up. so would like to know if it is the fuel pressure low fuel pressure presents as misfires and lack of power not increasing rpms indicates accelerator position ...
Question about Chrysler PT Cruiser
...without my car since June 11, 2012. check fuel pressure,if not 30psi or more then remove fuel filter and turn ignition on and fuel should come out with a little pressure,if not fuel pump is
...fuel pressure checked.Most probably fuel pressure is low.It cranks few times this indicates that fuel is not reaching to the engine, so it cranks.When required fuel slowly slowly reaches the engine, ...
...checking fuel pressure to make sure it is within normal specs If fuel pressure is too high due to a faulty pressure regulator for example, it will cause too much fuel to be entering the engine. A ...
Question about Chrysler PT Cruiser
fuel getting through to start the car? Fuel pump was replaced and is working Bad filter, no injector pulse (use noid light to check this), bad fuel pressure regulator (test pressure key on engine off)
fuel pump fuse and relay. The engine is getting fuel at the rail. The fuel pressure should be 58 psi. It can vary 5 psi but if it is more than that the engine will not have sufficent pressure to start
...Fuel Pressure Regulator is a simple mechanical device that holds constant fuel pressure or relieves excess fuel pressure by way of the pressure compressing an internal spring and opening an orifice ...
...has a full charge. Have a helper crank it, while you visually check for spark at the spark plugs. If spark everywhere, use a gage and check proper fuel pressure. Also, check fuel injector
fuel pressure, 2.4L non-turbo, my info says 58 psi, plus or minus 5 psi. Once you get the proper pressure turn the key off, see if pressure holds for a bit. Pulling the vac line off, leans the system.
1,571 questions posted
Usually answered in minutes!
1,198 Questions
1,147 Questions
816 Questions
677 Questions
582 Questions