2001 Chrysler 300M "cam sensor" Questions

...cam sensor 3.5L suspect cam and crank sensor out of sync (according to scan tool) swapped pcm starts other car fine. timing belt and cam sprocket alignment procedure complete. however left sprocket ...

...300M and am getting fault codes P0344 & P0340. Any ideas of the issue and if the fix is something a can do? Those 2 codes are for the cam sensor. Replace the cam sensor and that should fix your

...Cam Sensor,but car cuts out like "red lining" at 2400RPM.... After you replace any sensor like cam or crank,plug scanner and go to special function.select RPM learn and folow the instruction. the ...

One cause is oil or dirt getting on pickup coils, cam position sensor, also if cam is worn and moving any that will affect the gap between sensor and cam. You didn't say how many miles were on the car

...cam shaft sensor bad? Code 16 is for a problem where the correlation between the crank sensor and the cam sensor for bank one is off. So yes it could be the cam sensor or the timing belt. If ...

...cam sensor already. could it be the crank shaft sensor or any suggestions? Was the cam sensor tested & was it found to be bad? Was the fuel pump checked out or fuel pressure checked? Always learn ...

...CAM position sensor fault. More specifically it is an Intermittent cam shaft position sensor code. The likely cause of this is that you will just need to replace the sensor, typically they run from ...

car shut off while driving will not start again run fault codes and check for cam/crank position sensor. Check that the cam shaft is still turning ( broken cam belt)

...cam sensor is in the timming cover just above the left camshaft gearremouve the  small bolt and it pulls out push in the new one all the way hold it in and  tighten the bolt very much ...

cam sensor is bad. i have a 1999 chrysler 300m. while driving the car shuts down and won't turn over soon after. i took it to auto zone and had it tested and the machine read shaft cam position sensor