2006 Cadillac Escalade "fix heat gun" Questions

...heat how do u fix the little to no heat in a 2009 jeep patriot fan blows? engine reaches and holds 180F or more , normal engine temp? (use a IR pyro gun to measure it) ever go a cooling system flush, ...

clips that glue onto the lower window broke. The door panel will have to be removed, the old clips, heated with a HOT heat gun and removed, and new ones installed. Pretty easy fix with the right equip

fix this Under the rotor cap is a object with 6 evenly spaced points that rotates in front of a magnetic pickup. Remove the magnetic pickup and connect a ohm meter to the two leads and heat it up with

heat, heating it makes the +NUT expand and cracks the rust bond. i use my impact gun i use my air hammer for the hard cases. or get a spare used arm and fix it first, then put it on. tools will get it

...fix. Tools you will need are a small flat head and medium cross head scredriver, solder gun and electronic grade solder, small heat shrink tubing. Remove the entire center console - start at the rear ...

...fix/replace the mirror glass and backing plate of the driver side mirror unit? The outside casing is still intact but the mirror glass and its plastic backing have been broken off. it is a electric ...

...is your anti-freeze level ...if that is good put a thermo-gun to your thermastat housing and see if the themastat is opening at the proper temp ...may just be stuck closed cheap fix flush the ...

fix dented rear bumper the corner of the rear bumper is pushed in but there isn't any serious damage to the car. Take the bumper off you'll need a heat gun to heat it up but not hot enough to melt the

...fix dent in bumper cover If you want to repair yourself, I would start by taking the bumper cover off, then slowly warming the dent area (front and back of the cover) with a heat gun (careful as you ...

...fix them so they will not re-break. CAUTION: Do Not put them together right where the break is because they will re-break. Instead, take a long piece of wire and attach it to the door side wire, then ...