2001 BMW 325 "replacing rear wheel bearing 1988" Questions

...rear left tire BMW 325i 1988 Mechanic said that is the Drive Shaft, did not give me a price yet. Talked to other mechanic for a second opinion, he said that it is very expensive to replace the Drive ...

...bearing needs to be replaced. It could be drive shaft joint. the car is rear wheel drive with independant suspension. I do not think there is a bearing there. It may also be the brakes need

replacing 1988 toyota 4 wheel drive truck rear end wheel bearing the rear wheel bearings are sealed units, that are pressed on the axel. you must have a press to get them off or on. You do not not a ...

...replacing races then punch them out and tap new ones in, repack new bearings with grease install rear one and install new grease seal, slide rotor on slide frt bearing on, install washer and nut, ...

...REAR AXCEL BEARINGS ON A 1988-Chevrolet-IROC-Z28-CAMARO Put car in neutral, remove wheels, calipers and rotors, diff. cover. rotate carrier until you see wrist pin retaining bolt, remove bolt and ...

driving but I isolated the problem to the right rear wheel bearing and repaired it myself, other than a machine shop pressing of the new bearing onto the axle. Out of pocket expenses was less than $75

...rear right. i passed thru a 1 foot deep flood last sturday, then the following morning my wheels were stuck up. my brake pads/lining are new they were just replaced a month ago remove wheel and spray ...

...rear of the truck. Using a lug wrench, loosen the bolts that hold the driveshaft in place. Using a hammer, tap the driveshaft gently to loosen it from the carrier bearing. If the driveshaft does not ...

...wheel, take off the caliper and assembly, take off the hub lock assembly U can use a large nail or a couple small screwdrivers to take off the ring clips (2) one small and one large, take off the nut ...

rear axle - Dana 35 - has wheel bearings that run directly on the 2 half shafts (The axle half shaft..). This causes wear on the axle half shaft. This wear also causes the half-shaft to 'flex' and put