Question about Buick LeSabre
...cv shaft? I replaced the hub assembly on my 2000 lasaber and used my impact to put on the cv nut. It is screeching more now than before. what are the specs for this torque spec for nut is 118 ft ...
...2000 is leaking . told l need to replace the unit.were is it located on buick ???? Passenger side wheel well. Screwed in the block above the passenger side cv shaft below the power steering
...carriage of the care then you will need new boots or replace CV joints. Inner and outer wheel bearings can also make noise when they are about to fail. Check you service record for more
2001 Buick LaSabre Limited 3.8: 70-80 MPH shake I replaced the outer tie rod end on the passenger side, CV axel, and it still shakes at 70-80 mph. What else could it be? The roters in the front are ...
...2000 LeSabre shakes side to side at 38-48 mph ONLY when gas is applied past very light acceleration. You can't climb a hill without horrible shaking (not chugging). Either slow down below 40 or hold ...
...2000 LeSabre shakes side to side at 38-48 mph ONLY when gas is applied past very light acceleration. You can't climb a hill without horrible shaking (not chugging). Either slow down below 40 or hold ...
...replace both front axles, both front wheel bearings and research nose cone.." no mention of bending flex plate. estsmitated cost for trans work = $1000.00 Most likely, the clicking noise is a c/v ...
...CV axle or the hub bearing I had the same problem with my 2000 Buick LeSabre last year. Took it in and they determined the wheel bearing needed to be replaced. Costs about $300 per bearing, but ...
2000 lesabre makes noise when turning stering wheel If the noise is a clicking sound then your CV joint is worn out and needs replacing. Do both sides at the same time.
523 questions posted
Usually answered in minutes!
1,731 Questions
1,603 Questions
1,084 Questions
904 Questions
897 Questions