2005 Pontiac Grand Prix "pressure control solenoid replacement" Questions

job.. CHECK THE TRANSMISSION FUSE.IT CONTROLS TORQUE CONVERTER LOCK UP SOLENOID - PRESSURE CONTROL SOLENOID VALVE - 1 -2 SHIFT SOLENOID - 2 - 3 SOLENOID.IF FUSE GOOD YOU NEED A FLUID AND FILTER CHANGE

...pressure control solenoid on the transmission, is it shifting hard?? Its located underneath the side cover of the tranny. You may have to lower the sub frame to gain clearance to get the cover off, ...

...Pressure Control) solenoid failed. Easy fix in pan. Fix as soon as possible or hard parts will eventually break. Thank you for using fixya and good luck. Before guessing at transmission problems, ...

...control solenoid on my 04 pontiac grandprix 3.8L, 3800 series 3..do you have a diagram where i can locate it. also the transmission fluid was changed yesterday..the only reason i am doing this is ...

...Control Module (PCM). It is based on engine coolant temperature, engine speed, vehicle speed, throttle angle and Manifold Absolute Pressure (MAP). The operation of the EGR system is monitored by the ...

Pressure (MAP) sensor Idle Air Control (IAC) valve Throttle Position (T/P) sensor EVAP purge solenoid Install or connect the following: Throttle body upper support bracket bolt. Tighten the bolt to 89

Pressure Control Solenoid(5)Bore 5, Pressure Relief Valve(6)Bore 6, PWM and TCC Control Valve(7)Bore 7, TCC Regulator Apply Valve(11) Bore 11, 3-4 Shift Valve, 4-3 Manual Down Shift Valve(12) Bore 12,

...control clutch.Majority of the time, it is a torque converter clutch solenoid. This solenoid controls the hydraulic pressure to both apply and disengage the torque converter. When it is ...

control solenoid valve. This will measure the pressure from the air moving through the system into the exhaust. Expect to see 8-10 kPa higher than the KOEO kPa reading (or 1.16 to 1.45 PSI higher than

...control module monitors the fuel tank pressure (FTP) sensor voltage to verify that the system is able to reach a predetermined level of vacuum within a set amount of time. The control module then ...