1998 Nissan Frontier "distributor marks" Questions

Ad

Question about Nissan Frontier

1 Answer

...marks properly aligned, install distributor with rotor pointing to the number 1 pole on the distributor cap. leave room for timing adjustment, by slowly dropping distributor into hole & carefully ...

Ad

...distributor. which timing mark ( has about 6 marks)on the crankshaft pulley and does it align with the pointer that is attached on the block when the # 1 piston is at TDC.also whats the torque on the ...

Ad

...it rain last night?). It may be that the contoured rubber seal that's located at the base of the distributor cap has failed allowing moisture inside the cap. The seal alone is not available

...Center (TDC) of the compression stroke for the No. 1 cylinder. Remove or disconnect the following: Distributor cap Distributor Engine under cover Stabilizer bar Oil pump and drive spindle To

Question about Nissan Frontier

1 Answer

distributor n timing belt If it's the timing belt you may have it a tooth or two out. Take the cover off and turn the engine till the timing marks are on and see if they are all on their marks. Sounds

Question about Nissan Frontier

1 Answer

...marks on the crankshaft pulley, not sure what it aligns with. the engine will start now. its a crankshaft sensor on a fixed toothed ring so it cannot move ,unless you have a distributor and i dont ...

...with an open valve instead of both valves closed, you are exactly 180° off. Tou can turn the distributor 180° and see if that helps but, it will mess with anyone else that would ever work ...

Question about Nissan Frontier

1 Answer

marks on the left side camshaft sprocket and the crankshaft sprocket. While keeping the tensioner steady, loosen the locknut with a hex wrench. Turn the tensioner approximately 70-80 degrees clockwise

...on me once at a red light then again when reversing in my parking spot. After work we changed the distributor cap but that didn't work. Our friend "a mechanic" disconnected the fuel line and when

...marks for installing the new distributor. Be sure that the new distributor has a new gasket or seal and that any old gasket material has been thoroughly cleaned. Then lower the distributor into the ...

Not finding what you are looking for?
1998 Nissan Frontier Logo

642 questions posted

Ask a Question

Usually answered in minutes!

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...