2000 Ford Windstar "van door latch" Questions

Ad

van keeps "dinging" like an door ajar alarm. Stops dinging when van hits 17 mph This means one of the door ajar sensors is stuck. You need to remove the door trim panel and then the latch and then the

Ad

VAN, THEN THE LIGHTS GO OUT. ALSO NOW THE ODOMETER AND SPEEDOMETER IS NOT WORKING, CRUISE CONTROL IS NOT WORKING EITHER NOW AS WELL. THE O/D LIGHT HAS STARTED FLASHING. AND FINALLY THE AIR CONDITIONER

Ad

...your latch might only be partally connected look around were the handle is or were the door latches into the van to see if theres any loose bars or cables in the door more than likely thats the ...

Question about Ford Windstar

1 Answer

...van and try to force the sliding door open at the rear where it swings out on the rails. The latch is going to have to be jarred loose. If you get it open, check and make sure the "fingers" on the ...

door fully by pushing it forward (may require several hands pushing at once) which may reset the lock and latch. If it closes, but still doesn't release the lock, the interior panel must be removed to

Question about Ford Windstar

1 Answer

...van into drive , doors will not lock automatically and door ajar chime stays on continuosly. Most likely, the auto-locks aren't working because it thinks one or more doors are open. The door ajar ...

...door/van loading door switches has failed it thinks a door is open so the the interior light stays on and the door open warning will ding the interior light should have a switch to disable it or take ...

Question about Ford Windstar

1 Answer

...van it shows that a door is not shut but they are and the inside lights won't go off THE DOOR AJAR SWITCH WHICH IS LOCATED ON THE DOOR LATCH IS STICKING, THE PART IS CHEAP, BUT THE DOOR PANEL MUST ...

Question about Ford Windstar

2 Answers

...van The blender door actuator, the one that most commonly fails on Windstars, is located behind the radio. Remove the radio to gain access. Is white. Remove the door panel then remove the door latch ...

...inside the van, but not while pulling on the door handles as they should. Any suggestions? Sounds like the mechanism inside the door has come off, should be a rod and clip that holds it to the

Not finding what you are looking for?
2000 Ford Windstar Logo

2,292 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1998 Ford Windstar
1998 Ford Windstar

1,830 Questions

2001 Ford Windstar
2001 Ford Windstar

1,838 Questions

1999 Ford Windstar
1999 Ford Windstar

1,212 Questions

2003 Ford Windstar
2003 Ford Windstar

1,032 Questions

1996 Ford Windstar
1996 Ford Windstar

600 Questions

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...