1993 Ford Ranger SuperCab "heater hose hot" Questions

...heater hose returning from the core to the water pump is NOT hot, while the hose going to the heater core from the thermostat area IS hot, then the heater core is plugged probably. You need to remove ...

...heater core clean with a water hose, it may be time to replace. Try flushing or blowing high pressure air through the heater core lines. its sludge build up and need to be flushed through heater core ...

...hose is hot, you may have a blockage in the heater core. This usually means replacing the heater core, but you may be able to flush it. See this YouTube video: ...

...hose on one inlet of heater core for a minute and then the other.. keep going to you get a good flow...make sure heater valve is open, not just valve position take loose and confirm clear..last make ...

...truck blows whatever the air temp is out side with heater on hot. how old is the thermostat? are any hoses cracked or sucked together. heater core may need to be flushed or replaced? good

...heater core under the hood at the firewall, use a garden hose to flush the core out, if the core doesn't appear plugged u will need to pull the dash out and replace the temperature control blend door ...

hose....Hold it higher than your radiator and then have some help and fill the tube with water this will force air into the tube from your heater core. was the thermostat put in the right way?,did you

heater core in the engine compartment. Tighten the hose clamps. Add coolant until the level is between the minimum and maximum marks on the reservoir. 8. Replace the battery cable and start the engine

...heater hose. dont use a high pressure hose, just a garen hose with a sprayer on it. It sounds like your blend door is broken or the actuator that controls it is.  This is sadly a VERY common ...

...heater hoses (half the diameter of the radiator hose, twice as long, and they both go into the firewall next to each other.) If one is hot, and the other is cold, your heater core is plugged. If they ...