...is how can i hook my 99 knock sensor up to the 97 motor As long as you can get it bolted to the engine somewhere it should work OK. I hope thats all the difference between those 2 engines.
...knock is a rod. You may also have a check engine light showing up on the dash from the knock sensor. this means that a connecting rod or crankshaft bearing has failed in the engine, u will need an ...
...Faulty Knock Sensor. But my feeling is if the car has high miles its probably worn main bearings. Hey it could be crappy gas. Just depends if the knocking is at the bottom of the engine or at the
knock. And never listen to the advice at any parts store, have a trained techincian look at the problem. It sounds like you do have low oil pressure and it is not the sensor that is acting up. Tend to
where is the knock sensor.can i have a picture of the engine from autozone.com 2.2L engine 2.4L engine:
...engine possily the oxygen senser going out. the oxy sensor is in the exhaust if it is a 2.2 sfi there is 4 sensors on the back side of the motor. cam,crank,knock,and oil ...
...engine not up to operating temp. but the exhaust is starting to glow red. The cat.conv. replaced, no vaccum leaks. What could be the problem? The problem could be in the O2 sensor. It's reading the ...
...knock or tick even at 1800 rpm. NAPA parts store tech Theorized it could be a jumped timing chain. I've had the car for about 8,000 miles and I don't drive it very hard. gets louder and faster as I ...
swapping 2.4l engines on different year cavaliers and knock sensors are different.what can be done THey are only different ont the plug end. swap them also. And any othe rpart you run in to.
knock sensor on 93 chevy cavalier 2.2ltre located on the rear(firewall) of the engine below the exhaust manifold usually between the front 2 cylinders. it has a single wire attached to it and is about
1,907 questions posted
Usually answered in minutes!
1,849 Questions
1,641 Questions
1,529 Questions
1,438 Questions
1,200 Questions