...go back together If I'm reading your mind correctly, I'm assuming you were trying to do a break job and the new brake pads are too thick to go around the rotor? Easiest way is to **** ...
1989 buick century 3.3 V6 has no spark. Changed ign module, coils, crank senor, maf sensor, computer, ign switch. Traced wires no breaks fuses and fusible links are good. What can i do next? the ...
...box with a voltmeter and make sure theres power at the fuse box and if power at the box you have a break in the line follow to find the ...
Clanking knocking noise when going over some bumps and sometime when breaking hard. It does not always happen whn breaking - car has 82000 miles on it and has run fine - new front brakes in 9/09 rear ...
Anti lock breakes light is on along w/no track control light & yellow check engine light is on. Had tires and breaks checked out, no problems. Replaced a computer and hasn't solved problem Same ...
The left break light doesn't work but the left turn signal does work. The fuses are ok and so is the bulb. Why only one break light? The plug in for the bulb is bad,you can find a replacement for it ...
...to release the tabs and the cover will separate from the lower half. Be carefull not to break it - they break very
...sensor was changed as well. if the sensor was changed, the wiring to the sensor has to have a break in it somewhere. check for power and ground at your connector, and start tracing back to find ...
how do i remove a kick panel in a 1995 buick century ? I need to remove the kick panel to get to a break switch to reset it or replace it as break lights are one. model is the six cly 3.1 Kick switch ...
...to change the timing chain in a 2000 buick century? chains don't have to be changed unless they break which is hardly ever, belts on the other hand break at about100k hope this helps
1,263 questions posted
Usually answered in minutes!
921 Questions
813 Questions
797 Questions
687 Questions
554 Questions