...size is the nut on the front hub? I belive its a 32 mm socket that fits it, if the axle has been replaced it may be a 34 or 36 mm socket to remove, this nut is on real tight, i would go to a garage ...
...hub nut size Measure the nut in fractional size & divide by .0395Then you will have your metric axle nut size.34,36mm etc.One would assume you work on your own vehicles,that youhave all the ...
...SIZE TORQUE WRENCH FOR HUB RETAINING NUT.ITS TORQUE IS 170 - 202 FT LBS.MAKE SURE YOUR TORQUE WRENCH MAXIMUM RANGE IS AT LEAST OVER 200 FT LBS TORQUE.YOU WILL ALSO NEED A AXLE NUT SOCKET.ITS A BLACK ...
Question about Ford Cars & Trucks
...size socket required for a 2012 Ford Fusion Axle nut? Also, what is the Torque spec to secure it back on? Working with Front-Right wheel. The one that fits! That's not the way it works. you buy a ...
Question about Pontiac Montana
...size axle nut is on this as well as the e-torx on the back side. my socket set goes to 1-1/4": and 36mm. my e-torx kit has all sizes, one can need. with no sets. you must measure them. it's not ...
...size of socket I need? There are some special 4 tooth and hex sockets for removing the nuts inside the hubs of the truck. YOu can find these at NAPA or maybe AutoZone or Advance. I would go to NAPA ...
...size socket is required to remove the hub assemble? and 3) what size allen wrench is required to remove the bolt of the brake assembly so I can rotate the brake assemble out of the way to remove the ...
...size hammer. reverse process to assemble 4x4 this is a little more difficult than 4x2 you will need some specialty tools (torqs, picks, snap ring pliers, and a 2 3/4 inch rounded hex socket) these ...
...size socket to take the axle nut off the spindle if its 4WD. If 2WD they just bolt on from the back of the spindle (4 bolts), and electrical connector for the ABS. Leave the ball joints and tie rods ...
...size socket, remove the nut in center of hub. Some vehicles have a kotter pin in the shaft just in front of nut. If so, remove pin before nut. Next, you will need to loosen a few bolts that hold the ...
856 questions posted
Usually answered in minutes!
830 Questions
613 Questions
483 Questions
458 Questions
361 Questions