2001 Nissan Altima "hub" Questions

...altima 4cyl rear wheel bearing assemble install Go to YOU TUBE and put in replacing wheel bearing hubs fornissan altima & watchThere is a lot to see even if on a different vehicleI doubt you ...

Can I see a diagram for front passenger hub & bearinn on '97 Altima GXE (no ABS) I already replaced CV half-shaft a few weeks ago ---- now garage is saying bearing is shot, and had ruined part of ...

i recently changed the rear hub bearing assembly, the brake/caliper assembly and brake pads but there is still a pulsating screech while I drive but disappears when I step on the brakes. What could it

...grinding so I jacked the car up and removed the front wheels. I put the car in drive with the hubs spinning. When you apply the brakes there is a grinding noise that sounds like its coming from ...

where the speed sensor location usually at the wheel ...all 4 wheels may have sensors look for the wiring harness plug, behind the hub, or on the hub

...before installing the springs. a lot of time when putting on rear brakes you have to fight with hub to get it back on.check for rust on inside of hub, preventing it from sliding on. remove rust

How do you install front hub assembly on 2008 nissan altima? I just need the torque specs for front spindle as I will be replacing the hub assembly due to a bad bearing. Please advise The torque spec ...

how do I replace the front wheel bearing hub assembly on a 2006 nissan altima The front wheel bearings are pressed into the nuckle. You will need a kit to press them in and out or visit a shop or ...

and see if it's bent to .. if it is then you bent the axle not the rim. mostly what you need is the hub and or the hub and the strut assembly. replace the wheel it must be bent, I had the same problem

...the dealership and had it looked at. They told me i needed to replace the front wheel bearings and hub assemblies. They said they were unsafe. Can i do this at home? what are the tools required? I ...