...vale in the master cylinder. first i would suggest trying to bleed the breaks where you have had the pads changed. if it continues check the parking break switch to see if it is broken ...
...change the brakes cause they are starting to go bad, can someone help me? Front or rear brakes? The fronts are normal disc brakes, but the rears are drum. Basically, this means the fronts are super ...
...pads for this you may have to push hard. Once on put the 2 bolts back it tightly not over tight they do break. put back on your tire let it down then go inside and pump the brake pedal 2 to 4 times ...
change the rotors? an imperfection in the rotor can cause it to make a noise, you would think that the first mechanic would have changed out the rotors and pads to rule it out, i doubt it would be the
...break system. This needs to be done to give the fluid somewhere to go as the pistin pushes back in. Be certain to capture the fluid properly and dispose of properly. Don't get any on your paint as it ...
Intermittent grinding noise in right wheel well. Intermittent grinding noise in right wheel well as breaks are applied. Doesn't seem to be affecting the left wheel well at this time. Also, after ...
...break light came on, i slowed down and the light went from being bright to slightly dull. This stayed on for a couple of days. I check the fluids all were fine and then the light went out. What could ...
change the break pads for ford focus 2004 The following is from a tip I have posted for all cars but will work for yours, for removing the caliper bolt, a 7mm Allen wrench should be needed. First Here
Question about Ford Focus
...change break pads and calpier Turn on engine! Pump the brake pedal 3 or 4 times and stop with pedal depressed and firm! If the pedal starts to go down then the master cylinder needs looking at! most ...
1,391 questions posted
Usually answered in minutes!
3,749 Questions
2,612 Questions
2,055 Questions
1,226 Questions
840 Questions