2003 Ford Taurus "cam sensor" Questions

...the cam sensor. i'm not getting any voltage at cam sensor. it is two wire The cam sensor is a magnetic pick-up, and sends a signal the the computer. Its about $25 at any good parts

cam sensor, first you need to make sure the synchronier is good this is located next to throttle body and is where the cam sensor bolts to, these are known for making noise and going bad, if yours has

...cam sensor driver unit goes bad. (Usually called a "Cam Syncronizer") Squeeks like crazy, causes hard starts, poor fuel mileage, usually destroys the cam sensor itself, and will cause catalytic ...

...cam sensor a word of warning the main cause of cam sensor problems is that the magnet in the rotating part (or as ford calls it the syncronizer ) this magnet comes apart and actually hits the sensor ...

...cam sensor cam with a tool to align it, which I used. After clearing code and driving short distance same code p1336. What am I doing wrong. Any suggestions and help will be appreciated. Thank you in ...

...cam sensor is faulty. what cam sensor does is that it sense the turning of the cam and the sensor send single to ECU, than ECU tell the coil to released the charge from the coil to the plugs. The cam ...

...cam sensor I would say the code said the sensor was not giving the right signal.  Very seldom does a code state to replace a part.There may still be a problem with the camshaft or the ...

cam sensor or the injectors I have changed cmp/ckp/pcm/fuses/relays and checked grounds HI first does your check engine light come on when you turn the ignition switch on ,second if engine light comes

CAM Sensor correct? Or is this going to become one problem fix to find another? I would think it would be just the Camshaft Position Sensor.I looked up the codes and they say pretty much the samething

The car will not start. I have the timing right, gas, and spark. Is there a reset on the computer? Check the cam sensor or replace located on lower intake. Fixed a car like that it was the cam sensor