2001 Ford Ranger Regular Cab "ball joint" Questions

...ball joint, grease was put in and it got better for a bit but now sounds a bit different but is worsening again. It also creaks when i just push on the front drivers side suspension. The creaking is ...

...ball joint in my 1992 4wd ranger the ball joint has threads on it there should be a clamp on the end at the balljoint with a nut loosen the nut and take two wrenches. one on balljoint other on bar . ...

ball joint wear 1989 F150. Shop says u & l ball joints are worn beyond limits. Another says they are not. How do I check them myself u joints will flop around if worn. just block the wheels so it ...

...ball joint. i take off everything. i just wonder and can i take off both solid axle shaft so i can take off the ball joint The steering knuckle has to be removed so you can use a ball-joint press to ...

upper and lower ball joints bad on 2000 ranger xlt sport. i want to replace the parts myself if no special tools or equipment needed..........please advise If the ball joints are held in with rivits ...

...supporting the vehicle on the frame somewhere. You can buy a ball joint press kit for about 80$ online or use a really big hammer to smack them out. Putting them back in may be a pain without a

...ball joint pressed in it's best to remove the tornsion bar from the assembly as to relieve the tension caused by the the spring/strut assembly. you can leqave the cv float in the hub assembly

...ball joint out of the a-arm so that I can replace it? I have bad tire wear, especially on the right side. this is for a 99 Panger w/ coil springs do you have a suspension diagram for the front end ...

1998 Ford Ranger 4x4 How do you replace the ball joints rent a ball joint tool from your local auto store, they can be rough to install.

...ball joint. Then swing the hub away from the truck until it clears the a-frame. Next, pull the axle from the hub and finally pull it straight out of the tranny. You might need a drip pan in case the ...