2000 Ford Ranger SuperCab "running 4" Questions

Ad

...4 cyl and 5 speed. it runs fine, then occassionally after running for a while i shut it off and then it wont restart? have replaced computer? HELP..... lisen for the fuel pump to run when it acts up. ...

Ad

...running ok, all 4 were firing on the front coil, but on the back coil 3 & 4 still weren't firing. I'm not sure if the back coil makes any difference in the performance or just the pollution. I ...

Ad

so do i run the wire from coil spot #1 to cylender #1 then coil spot #2 to cyl #4...? The marks on the coils correspond to the cylinder it goes to Coil #1 goes to cylinder #1 Coil #2 goes to cylinder

...running, while you disengage from 4 wheel drive (low) to 4 wheel drive (high) and then finally to 2 wheel drive. It is critical to shift transmission into neutral when switching out of 4WD Low, as ...

1994 Ford Ranger 4.0 auto trans 4x4 engine runs fine cold, however after setting for 15 min at normal temp the engine runs ruough after restart untill it run for 3 to 4 min than runs normal. engine ...

...4 second between rpm?s if i pump the pedal itll seem to catch up? because if i get it to a higher rpm for a sec or two itll stay running. but if it cuts off when i restart it it starts up and runs ...

Question about Ford Ranger

2 Answers

ignition wiring changed sparkplug wires and motor runs really rough.need diagram to put wires where they belong please. I have a 95 Ford Ranger, 3.0,V6, need spark plug diagram, and firing orderto ...

number 4 cyl has low compressoin runs good at hwy speeds but idles bad has no power check the catalyc converter..when its clogged..vehicles run poorly especially at low speeds or idle

I am having trouble with it cutting out when you first start it after about 4 miles of driving it runs fine but the colder it gets outside the longer it takes to run right. I've had censors sparkplug ...

need vacuum diagram for 4-wheel drive need vacuum diagram for the 4-wheel drive on a 1999 ford ranger 4x4 off road 4.0 the 4x4 don't use vacuum. the front is auto lock when the transfer is engauged ...

Not finding what you are looking for?
2000 Ford Ranger SuperCab Logo

927 questions posted

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...