2000 Ford Excursion "v10 engine head" Questions

...v10 and 38000 miles it started running rough and discovered crankcase half full of coolant .Any ideas You may have a blown head gasket. One of the head gasket's job is to prevent coolant and oil from ...

...V10 reoccurring DTC 1299 P1299 - Cylinder Head Over Temperature Protection Active Indicates an engine overheat condition was detected by the cylinder head temperature (CHT) sensor. An FMEM Strategy ...

...v10 ford has never been know any good fuel milage, if your getting around 7 mpg your doing good I have 120,000 on a 2000 Van. No mechanical problems have only changed plugs, oil changes, and ...

Spark plug problems with triton v10 gas engine The spark plugs blown out cylinder head. How do you repair and how do you extend the thread.

...engine should either be the V8, V10 gasser or the 7.3 ltr diesel. All of these engines have timing and gears in the front side of the engine. The only ones that will need the cab removed or pulling ...

replaced to repair the problem, and that can be very costly. Always check the intake gasket first on V6, V8 and V10 engines. Then the cylinder head gaskets, cylinder heads and finally the engine block

replaced to repair the problem, and that can be very costly. Always check the intake gasket first on V6, V8 and V10 engines. Then the cylinder head gaskets, cylinder heads and finally the engine block

...V10, just had the engine replaced. For the last week or two, it has been "sputtering" off and on (but not continuously, just now and then). Today the "Service Engine Soon" light came on to accompany ...

replaced to repair the problem, and that can be very costly. Always check the intake gasket first on V6, V8 and V10 engines. Then the cylinder head gaskets, cylinder heads and finally the engine block

...gasket first on V6, V8 and V10 engines. Then the cylinder head gaskets, cylinder heads and finally the engine block. NOTE: Most common occurrence in this situation will be a failed head gasket ...