1999 Ford Windstar "vacume lines 3" Questions

...3 drive cycles.i noticed that the miss happens all the time between1300 rpm-1600 rpm..it has no miss before or after that rpm range... i think there may be tsb on this issue..any help apprichiated ...

Problem: Ford Windstar SE, 3.8L V6, 1999, front seat heat/defrost is alway cold with engine warm and heater turned on. Symptoms: 1) When (engine is warm and) front seat heat temp slider is moved from ...

...line from what i can remember most canisters have 3 lines 1 coming from the fuel tank 1 vacume coming from the engine(INLET MONIFOLD)1 coming out of canester out to the atmosphere,hope this

transit 07engine racing up@down sounds like you have a vacum leak in one of the vacum lines or you need to change the idle air control valve. start the engine and raise the hood and lisen for a vacum ...

...lines to your transmision,you need to look on the underneath side of your truck on the side of transmission for a loose or disconnected vacum line on the side of the transmission. when you feel the ...

has a new booster if it is not vacume what could it be. Yes, it is vacuum operated. Would be your largest vacuum line(1/2 to 3/4 inch diameter hose, usually off the intake manifold or an intake runner

...3 bolts on the firewall that you remove after disconnecting the reservoir. There are no electrical connection on the master cylinder unless it is a sensor and it doesn't sound like you have a sensor ...

...3 port switch,a 2 port brown vacume switch on intake and a 2 port black colored vacume switch in-line on timing cover heater hose outlet.I need a diagram for the proper routing of these emission ...

...3/98 auto that dies when you put it in gear to take off. I have had the airflow meter re-calibrated and flow tested fuel pressure is ok. You have to press on the accelerator alittle bit to get it ...

i have a 1991 3/4 ton chevy van and today the transmition started shifting late check make sure the vacum line is attached to the vacum canister on the back of the trans if it is then might need to ...