1999 Ford Windstar "adjust door sliding" Questions

door frame, adjust the rollers to be all the way up into the frame. Once you have the sliding unit back in the door frame you can adjust the rollers for optimal performance. Keep adjusting the rollers

sliding door leaks, rattles, and doesn't always shut all the way. Have to give it a little exterior ''hip action'' to get the rear of the door to latch shut. Also sometimes it mysteriously slides open

...open passenger and sliding door locks. After each pus the lock will go up little by little. Please Help. SOUNDS LIKE THE LOCK MOTOR MAY BE OUT OF ADJUSTMENT AND NEEDS ADJUSTING AND A LITTLE LUBE ...

the tailgate, and press on the rear side of the sliding door(s) (or open-close the sliding door(s)) to make the light go off. It also is possible that a latch may be defective or in need of adjustment

...on and is running down the battery One of your door switches has failed, needs adjustment, or wires to it have broke. I'd start with the sliding doors, they are probably highest suspect in a

sliding rear door lock does not unlock completely. unlocks and then relocks itself when using either clicker or door locking switch. Any suggestions? This is an adjustment best done by a professional.

...up and press switch to find out if it is the switch or the door latch needs adjustment. Usually the sliding side door is the one with this type of problem. Don't forget to rate this answer, Good

...car is going for scrap. One Other Thing engine light on . diagnostic says too lean hoe is it adjusted and where. does it mean not enough air or gas. Aligning pulleys on auto sliding doors need ...

my rear brake light doesnt go off even after i remove the key from the ignition and close doors. What could be the problem? Take a look under the dash, there is a brake light switch. This switch has a

...sliding door on 99 ford windstar it has power door ,it is a handicaped van,i'm adjusting the rollers upper,mid,lower .the door came off and customer ask if i could put it back on,i did,but i cant get ...