...security feature found on most (if not all) new Ford products, and what it does is disable your vehicle's starter unless your specially programmed key is used to start the vehicle. There is a ...
vehicle. Install a minimum of 10 gallons of fuel and check for leaks. Install a pressure gauge on the throttle body valve and turn the ignition ON for 3 seconds. Turn the key OFF , then repeat the key
Question about Nissan Cars & Trucks
vehicle security relay terminal 2 (models with vehicle security system). With the selector lever in the P or N position, power is supplied through PNP switch terminal 2 to PNP relay terminal 2. If
Question about Ford Windstar
...vehicle will not start). Observe the SECURITY light, after approximately 10 minutes the light will turn OFF. Turn OFF the ignition, and wait 10 seconds. Repeat steps 1 through 4 two more times for a ...
...Sec Sys Sensor Data Incorrect but Valid DTC B3031 Security System Controller in Learn Mode DTC B3033 Security System Indicates Tamper . Your best bet , take your vehicle to a qualified repair shop
Question about Ford Windstar
...vehicle will start and then stall. Leave the ignition ON until the security telltale turns OFF in 10 minutes. Repeat Steps 3-5 for 2 more times (3 times total) The Passlock™ controller will learn the ...
Question about Ford Windstar
...vehicle will not start). look at 'security light', after approximately 10 minutes it should shut off 4. Turn off the ignition, and wait 5 seconds. 5. Repeat steps 1 through 4 two more times for a ...
...security indicator, refer to Vehicle Theft Deterrent (VTD) Description and Operation . ?€¢ The CTD system requests the IPC to illuminate the indicator only when the ignition switch is OFF. The CTD ...
...vehicle will not start. Observe the SECURITY telltale. After approximately 10 minutes, the telltale will turn OFF. Turn OFF the ignition, and wait 5 seconds. Repeat steps 1 through 4 two more times ...
Question about Ford Windstar
vehicle security module that year . If intermittent, possible lose ground wire , door ajar switch The alarm system does not operate correctly Door ajar input(s). Circuitry. Vehicle security module. Go
2,613 questions posted
Usually answered in minutes!
1,838 Questions
1,503 Questions
1,212 Questions
1,032 Questions
600 Questions