1998 Ford Windstar "truck starting hard immediately shutting" Questions

Ad

...immediately and will not shut off when the key is in the ignition even though all seat belts are done up and all doors are closed I'm an out dated mechanic, but i believe the drivers seat belt ...

Ad

immediately. Sometimes when car is parked on an incline it is hard to start. Today while driving at 35 mph the engine died. The car started immediately after stopping. Fuel filter has been changed but

Ad

Question about Ford Windstar

1 Answer

...97 oldsmobile aurora has a bit of a hard time starting on a chilly morning after about 7 turns of the key it jumps over n starts fine immediately after shutting it down temputer sensor needs ...

...hard start acting lot not firing and finally starts and immediately runs great. . Can restart fine if done within a few seconds after shutting off then have to go through hard restart again. Replaces ...

...hard and engine light comes on, then I shut off engine and immediately re-start and it runs fine, engine light off. I have replaced igniter and coil to no effect. Can anyone help? You have 2 codes, 8 ...

...brights, washer fluid comes out. this all started immediately after i hit the lever pretty hard with my hand when swerving to avoid hitting something. It sounds like your multi funcion switch is ...

...Hard to Start or No Start Scan Data for Starting Problems I would think the crankshaft position sensor or ignition control module could be the problem , but without testing ,that's just a guess

...truck or a diesel engine). Drove for another 2 kms and turned off the engine. Started the car after 45 mins. Sound was still there and drove for about 1 km and the sound became louder and then the ...

...truck is running. Hard to start and when shut off, pressure bleeds off almost immediately. Nothing wrong with fuel pressure should be fine. Pressure should not bleed off when vehicle not running that ...

Question about Cars & Trucks

1 Answer

...immediately shut off. then will not start. the fuel pump works well when you send 12v to it. the codes say the ecm is not getting a tack signal. would this be a bad crank angle sensor. it is in a bad ...

Not finding what you are looking for?
1998 Ford Windstar Logo

2,613 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2001 Ford Windstar
2001 Ford Windstar

1,838 Questions

2000 Ford Windstar
2000 Ford Windstar

1,503 Questions

1999 Ford Windstar
1999 Ford Windstar

1,212 Questions

2003 Ford Windstar
2003 Ford Windstar

1,032 Questions

1996 Ford Windstar
1996 Ford Windstar

600 Questions

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...