1998 Ford Windstar "clear codes" Questions

Need to clear code after overheat problem Do not have a reader or scan tool and need to clear codes? Should be able to get an auto parts store to clear it for you

Engine code p0304 1996 Ford windstar. replaced plugs.wires, coil and injector. still have code, any ideas? If you haven't already had the code cleared, get it cleared at AutoZone or Advance Auto ...

ecm wont erase codes The codes need to be cleared manually. Either at a shop, or you could possibly disconnect the negative battery cable for about 15 minutes. Sometimes this will clear the codes

...clear the codes and the light went out. Is there a sensor that needs to be replaced to prevent this from occurring again? a check engine light comes on when the system detects a recurring issue.. ...

how do you reset code A code reader has the function/ability to reset codes. If you do not have access to this tool, disconnecting the battery for 30 sec will normally clear the codes as well

...3.8 check engine goes out normal there are no codes but there is 5 inc that wont clear remove battery connection and wait about minute and replace..In some cases this will clear it...good

...throwing this code. Shouldn't keep it from starting, but ya never know. Try unhooking the ground on the battery for aprox 30min to clear the code. If it starts, drive a few miles and recheck

...the codes? If not, you probably just deleted the information needed to get your van running again. Clearing codes will not, in itself, cause the engine to not

...clear. sometimes codes just have to be cleared manually using a scan tool. you can try disconnecting the battery negative terminal for 5-10 minutes, but this action may require time for the computer ...

...for this is a window feedback, that Ford does not use in there GEM module, satisfy the misfire clear the code and recheck ...