...vic pi I had to change the transmission range sensor .. bout it from a ford dealer for just under a 100.00 dollars Any luck figuring out this issue, i also have a 06 Ford Crown Vic that does the same ...
...vic, but it runs and starts great. Serpentine belt was replaced in 2010. There is a rubber smell when running the AC. Any ideas what the light means? What I should check? HelloWhen the service ...
...vic,i can only get to about 45-55 mph. If your overdrive light is flashing, it is trying to tell you that there is a transmission failure. You will have to scan your powertrain control module to find ...
...Vic interceptor with 185,000 miles. The car only misfires when the temp is below 50 degrees it stumbles really badly. I have changed the temp sensor, plug boots for the individual coil packs, I have ...
...vic trunk release doesn't work Also, door locks lock, but don't unlock Do you know if your door locks are module controlled or non module controlled ? Locks, Latches and Entry Systems - Module ...
vic police intercepter and the transmission is sticking in first gear and when i let off the gas it shifts. what could be the problem? and oh i already did a trans flush. thereis a transmission module
Question about Ford Crown Victoria
...Vic that depends on transmission, non computer shift transmissions have a vacuum shift diagram. round cyclinder on back end of tansmission. if it goes bad it will cause your car to smoke, sucking ...
Question about Ford Crown Victoria
Transmission is shifting hard what would be the cause, it is on a 1986 Crown Vic, what would cause this? A failed vacuum modulator, a vacuum leak in the hose that goes to it.
...vic that I purchased, the prev. owner said that they had the O/drive disconnected as they only drove it in town, all the mech. linkage is connected, it only drives in first, so what do you think they ...
Question about Ford Crown Victoria
vic police car... well recently i noticed the car was idling rough and the check engine light would flash and stay on! so i got a diagnostic test ran on it and it gave a code for a cylinder4 misfire..
429 questions posted
Usually answered in minutes!
454 Questions
486 Questions
323 Questions
297 Questions
294 Questions