1996 Ford Escort 4 Door "disc brake replacement" Questions

...brake judder..ive had new pads/discs,cv joint,bearings,drive shaft.yet i still got juddering when breaking(not as bad as b4)garage says only thing left is faulty discs(very slight ridge on front n/s ...

disc caliper now bleed the brake master cylinder. strongly kick the brake.keep it in pressed condition and pour in the brake oil. now release the brake pedal and push it for two times and then release

...disc brake caliper locating pins (2B296). 6.Remove the front disc brake pads and shims from the disc brake caliper (2B120). 7.Compress the caliper piston completely into its BORE NOTE: Apply a thin ...

disc had fallen out and was broke. It seems this keeps the brake lights from staying on all the time. Do you know what it is called so I can tell the parts dept what I need and can I install it myself

...disc came from the brake light switch. You state that the brake lights will not go off. The solution is a relatively easy fix. Under the dash near steering column, attached to the brake rod (or above ...

...brake disc then push the 2 apart, once these have been moved lift the caliper off and the brake pads should come free. the caliper has a cylider/ round part that pushes the pads against the disc ...

...brake disc rotor or a very worn set of brake pads. a) Warped and cracked brake rotors are most often caused by heat build up due to a brake caliper seizing and leaving a brake pad engaged with the ...

...disc is broken, the brake pedal arm doesn't touch the button that shuts off the lights. There is one replacement disc near the switcht that you can use. If is has deteriorated at the same rate as the ...

...disc brake caliper retaining bolts. Remove the disc brake caliper and secure the caliper aside with mechanic's wire. Do not disconnect the brake hose. Pull the brake rotor from the hub. Inspect the ...

...disc pieces on the car floor. Of course, my brake lights are on, draining the battery. I have never looked under the dashboard (are there lots of wires?!) nor have I disconnected wire circuitry in a ...