1994 Ford Mustang "cam sensor" Questions

replaced both cam sensors had check eng light turned off and light came back on and code comes back as cam sensors check the wireing to the sensors< also there is a special too to set the cam ...

...sensor Bad cam sensor Damaged wiring to crank/cam sensor Timing belt/chain tensioner damaged First, visually inspect the cam and crank sensors and their harnesses for damage. If you notice ...

If both cam/crank position sensors have ONLY been unbolted and replaced with new sensors, do they require synchronization? Error code P1336. Cam or crankshaft HAS NOT been replaced. Only sensors. ...

...cam sensor. The pump should run for 3-6 seconds when the key is first turned to the "on" position and then when the ECU registers pulse from the cam sensor it sends the signal to the relay to run the ...

...cam sensor is usually magnetic and the cam sensor Hall effect. I am 95% sure that your fault lies with either one of there sensors. 2 pin socket (magnetic - sine wave output). One pin is 'ground' the ...

sensor, replaced cam shaft position sensor, cleared codes, light comes on again, the code reads cam shaft position again as well as engine running lean. Kwik Kar cleared those codes and recommended to

sensor with throttle body cleaner i have a bigger cam and my car seems to do that too i think than from the cam the car has problems with air-fuel ratio especially if it hasn't been tuned properly and

my 2002 mustang GT hasits a misfire on cylinder 3 and misfire on first 1000rpm ive replaced the plugs,coil packs,injectors,crank sensor and cam sensor Clean the mass air flow sensor.

how do i locate and change a cam position sensor Look at the heads there should be a black sensor bolted to one of them. I think its a 9 mm bolt.

3.8l Why is there no spark? Replaced egr spark cable and wires, cam shaft sensor, crank sensor I have fuel and combustion but no spark at the spark plugs ECM computer